Just Restocked｜Mako® 65W High-Power Electronics｜ Electronic Accessories

Unlock the full potential of your existing Mako® Hotend with the Mako 65W High-Power Electronics. Designed specifically for the Mako Hotend for Bambu Lab X1 and P1 series printers, this upgrade replaces the stock heating electronics with a 65W ceramic heater, providing the additional heating power needed to achieve higher flow rates and more consistent performance.
The original Mako was designed around a high-power heating system, but various factors prevented us from releasing it with a high-power heater. The 65W High-Power Electronics finally delivers the heating capacity the Mako was designed to use.
With 65W of heating power, the Mako can reach and maintain temperature more effectively at high flow rates. This is particularly beneficial when printing with larger nozzle sizes and high-temperature materials, where the stock heater can become a limiting factor. The increased power also provides faster heat-up times and greater temperature stability during demanding prints.
The 65W High-Power Electronics are an upgrade for existing Mako Hotends. The physical Mako Hotend itself remains unchanged, retaining its rigid roll-cage design, high-performance aluminum fan, and interchangeable GammaMaster® Nozzles.
For the best results, use the 65W material profiles available in the Downloads section of the Mako® 65W High-Power Hotend for Bambu Lab page. Disclaimers:

This product does not include a fan. If you need one, please purchase one from our High Performance Fan for Bambu Lab page.
Temperature Limitations: Although the Mako Hotend is rated up to 360°C,   Bambu Lab Printers are limited to 300-320°C by the firmware depending on the model.
Unlike the previous design, which relied on the stock heater and a separate adapter, the new heater occupies the entire footprint of the heater slot for maximum thermal performance. So, the heater adapter is no longer needed.
Brand:Slice EngineeringCategory:AccessoriesSKU:A-M6E-HO-1361-P1STags:Consumer only, mako, mm_extra_savings_tag, mm_extra_savings_tag_2, mwe-googleytapp-channel, mwe-non-retail-set-up, onadditive_product_exportPrinter:P1P/P1S, X1/X1C, X1E